Chapter 5 Initial Setup Example
XS1930 Series User’s Guide
69
2 In the Static VLAN screen, select ACTIVE, enter a descriptive name in the Name field and enter 2 in the
VLAN Group ID field for the VLAN2 network. Use the default VLAN type, Normal, in the VLAN Type field.
Note: The VLAN Group ID field in this screen and the VID field in the IP Setup screen refer to the
same VLAN ID.
3 Since the VLAN2 network is connected to port 1 on the Switch, select Fixed to configure port 1 to be a
permanent member of the VLAN only.
4 To ensure that VLAN-unaware devices (such as computers and hubs) can receive frames properly, clear
the TX Tagging check box to set the Switch to remove VLAN tags before sending.
5 Click Add to save the settings to the run-time memory. Settings in the run-time memory are lost when the
Switch’s power is turned off.
To Next Page
Loading...
