ZyXEL Communications ZYWALL USG 20 - How to Use Multiple Static Public WAN IP Addresses for LAN to WAN Traffic; Create the Public IP Address Range Object

Chapter 7 Tutorials
ZyWALL USG 20/20W User’s Guide
145
1 Click Configuration > Firewall > Add. Set the From field as DMZ and the To
field as LAN. Set the Destination to the IPPBX’s DMZ IP address object
(DMZ_SIP). Set the
Source to IPPBX_DMZ. Leave the Access field to allow
and click OK.
Figure 102 Configuration > Firewall > Add
7.12 How to Use Multiple Static Public WAN IP
Addresses for LAN to WAN Traffic
If your ISP gave you a range of static public IP addresses, here is how to configure
a policy route to have the ZyWALL use them for traffic it sends out from the LAN.
7.12.1 Create the Public IP Address Range Object
Click Configuration > Object > Address > Add to create the address object
that represents the range of static public IP addresses. In this example you name
it Public-IPs and it goes from 1.1.1.10 to 1.1.1.17.
Figure 103 Creating the Public IP Address Range Object