Chapter 18 HTTP Redirect
ZyWALL USG 20/20W User’s Guide
349
Finding Out More
See Section 6.5.10 on page 99 for related information on these screens.
18.2 The HTTP Redirect Screen
To configure redirection of a HTTP request to a proxy server, click Configuration
> Network > HTTP Redirect. This screen displays the summary of the HTTP
redirect rules.
Note: You can configure up to one HTTP redirect rule for each (incoming) interface.
Figure 209 Configuration > Network > HTTP Redirect
The following table describes the labels in this screen.
Table 96 Configuration > Network > HTTP Redirect
LABEL DESCRIPTION
Add Click this to create a new entry.
Edit Double-click an entry or select it and click Edit to open a screen where
you can modify the entry’s settings.
Remove To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
Activate To turn on an entry, select it and click Activate.
Inactivate To turn off an entry, select it and click Inactivate.
# This field is a sequential value, and it is not associated with a specific
entry.
Status This icon is lit when the entry is active and dimmed when the entry is
inactive.
Name This is the descriptive name of a rule.
Interface This is the interface on which the request must be received.
Proxy Server This is the IP address of the proxy server.
Port This is the service port number used by the proxy server.
Apply Click Apply to save your changes back to the ZyWALL.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
