Chapter 5 Quick Setup
ZyWALL USG 20/20W User’s Guide
77
5.5 VPN Express Wizard - Scenario
Click the Express radio button as shown in Figure 39 on page 76 to display the
following screen.
Figure 40 VPN Express Wizard: Step 2
Rule Name: Type the name used to identify this VPN connection (and VPN
gateway). You may use 1-31 alphanumeric characters, underscores (_), or dashes
(-), but the first character cannot be a number. This value is case-sensitive.
Select the scenario that best describes your intended VPN connection. The figure
on the left of the screen changes to match the scenario you select.
• Site-to-site - Choose this if the remote IPSec device has a static IP address or a
domain name. This ZyWALL can initiate the VPN tunnel.
• Site-to-site with Dynamic Peer - Choose this if the remote IPSec device has a
dynamic IP address. Only the remote IPSec device can initiate the VPN tunnel.
• Remote Access (Server Role) - Choose this to allow incoming connections from
IPSec VPN clients. The clients have dynamic IP addresses and are also known as
dial-in users. Only the clients can initiate the VPN tunnel.
• Remote Access (Client Role) - Choose this to connect to an IPSec server. This
ZyWALL is the client (dial-in user) and can initiate the VPN tunnel.
To Next Page
Loading...
