ZyXEL Communications ZYWALL USG 20 - Configure the Policy Route; How to Set up a Wireless LAN

Chapter 7 Tutorials
ZyWALL USG 20/20W User’s Guide
146
7.12.2 Configure the Policy Route
Now you need to configure a policy route that has the ZyWALL use the range of
public IP addresses as the source address for WAN to LAN traffic.
Click Configuration > Network > Routing > Add.
Although adding a description is optional, it is recommended. This example uses
LAN-to-WAN-Range.
Specifying a Source Address is also optional although recommended. This
example uses LAN_SUBNET1.
Set the Source Network Address Translation to Public-IPs and click OK.
Figure 104 Configuring the Policy Route
7.13 How to Set Up a Wireless LAN
This tutorial applies only to USG 20W.
You can configure different interfaces to use on the wireless LAN card. This lets
you have different wireless LAN networks using different SSIDs. You can configure