Appendix A Log Descriptions
ZyWALL USG 20/20W User’s Guide
778
The connectivity-
check is activate for
%s interface
The link status of interface is still activate after check of
connectivity check process.
%s: interface name
The connectivity-
check is fail for %s
interface
The link status of interface is fail after check of connectivity
check process.
%s: interface name
Can't get gateway IP
of %s interface
The connectivity check process can't get the gateway IP
address for the specified interface.
%s: interface name
Can't alloc memory The connectivity check process can't get memory from OS.
Can't load %s module The connectivity check process can't load module for check
link-status.
%s: the connectivity module, currently only ICMP available.
Can't handle 'isalive'
function of %s module
The connectivity check process can't execute 'isalive' function
from module for check link-status.
%s: the connectivity module, currently only ICMP available.
Create socket error The connectivity check process can't get socket to send
packet.
Can't get IP address
of %s interface
The connectivity check process can't get IP address of
interface.
%s: interface name.
Can't get flags of %s
interface
The connectivity check process can't get interface
configuration.
%s: interface name
Can't get remote
address of %s
interface
The connectivity check process can't get remote address of
PPP interface
%s: interface name
Can't get NETMASK
address of %s
interface
The connectivity check process can't get netmask address of
interface.
%s: interface name
Can't get BROADCAST
address of %s
interface
The connectivity check process can't get broadcast address of
interface
%s: interface name
Can't use MULTICAST IP
for destination
The connectivity check process can't use multicast address to
check link-status.
The destination is
invalid, because
destination IP is
broadcast IP
The connectivity check process can't use broadcast address to
check link-status.
Table 254 Connectivity Check Logs (continued)
LOG MESSAGE DESCRIPTION
To Next Page
Loading...
