247Security Inc. | 4400 North Point Parkway, Suite # 158, Alpharetta, GA 30022, USA | 1-866-693-7492 | www.247securityinc.com
ZEUS mDVR
USERS MANUAL
44
g. Reset power and waiting for DVR to boot-up
h. After DVR boot-up, both ignition LED (green) and Power LED (green) should be on solid
i. Launch Internet Explorer
j. Type http://192.168.1.100/ to access DVR setup
k. Verify the new firmware version on the status page
5. Reconfigure System
a. After DVR boot up, both Ignition LED (green) and Power LED (green) should be on solid.
b. Launch Internet Explorer
c. Type http://192.168.1.100/ to access DVR setup
d. Update settings to the settings previously recorded on paper
e. Make sure the DVR name is exactly what it was before
f. Click “Apply” to apply the new settings.
6. Return hard drive
a. Make sure DVR Server Name on system configuration page is the same name on hard drive
b. And make sure the Force Power-on cable is removed from the GPIO2 port on the back of the
system
c. Turn the key lock to off position and wait until DVR powers off
d. Insert hard drive and close the Door
e. Turn the key lock to on position and wait until DVR boots up
7. Verify functionality
a. Launch Internet Explorer
b. Type http://192.168.1.100/ to access DVR setup
c. Verify new settings
d. Go to “Tools” tab and click “Download” to save new working configuration of the bus and
name the configuration file to something like bus name-current date.
e. Launch DVRViewer
f. Connect to DVR
g. Click “Play” and select “Live View”
h. Connect to DVR
i. Verify live view of cameras
j. Verify “Record” LED on Event Marker is on, indicating that DVR is currently recording video
k. You are done.
To Next Page
Loading...
