2N C-CURE 9000 - 6.5 Deleting a 2 N Intercom Object

Configuration & User Manual: 2N IP Intercoms and CCURE 9000
COPYRIGHT © 2022 2N Telekomunikace a.s. All rights reserved
Auth Type
Basic/Digest/None as per Intercom’s configuration.
DTMF Code
Enter the DTMF code to that will be used to open the C•CURE
door associated on the triggers tab. Only applicable for 2N
Devices.
This Code must match with “Switch Code” in 2N intercom
configuration and “Unlock PIN” in 2N Master Station
configuration.
Workstation
Enter the workstation PC name as described in the workstations
of C•CURE that the device is associated with. Only applicable for
master stations.
4. Click Save and Close to complete the configuration.
6.5 Deleting a 2N Intercom Object
This section describes how to delete a 2N Intercom Object.
Please be advised that deleting a 2N Intercom object won’t affect linked objects such as
C•CURE events and C•CURE journal messages. Even though a 2N Intercom object is not
present, C•CURE objects remain in place allowing historical data and events to be
viewed.
6.5.1 To Delete a 2N Intercom Object
1. In the Hardware pane, under the 2N Intercoms folder, select the 2N Intercom Object.
2. Right click and select Delete from the context menu.
3. Confirm the delete operation by pressing Yes, then OK.