Configuration & User Manual: 2N IP Intercoms and CCURE 9000
COPYRIGHT © 2022 2N Telekomunikace a.s. All rights reserved
4.3. 2N IP Intercom HTTP API Activation
Configuration is required on the 2N IP Intercom devices to allow the connection from C•CURE
9000.
The procedure to set up the 2N devices is as follows:
• Under Services → HTTP API make sure all APIs are enabled and set to Digest
Authentication. The connection type can be Secure (HTTPS) or Unsecure (HTTP), the
corresponding configuration must be set on the Communication Configuration
parameters later.
• Under one of the Account tabs, enable an account that will be used to connect from
C•CURE 9000. Use the following User Privileges settings:
To Next Page
Loading...
