Configuration & User Manual: 2N IP Intercoms and CCURE 9000
COPYRIGHT © 2022 2N Telekomunikace a.s. All rights reserved
6.6.1 General Tab
The following table provides the fields and button definitions on the General Tab:
Check this checkbox if you wish to use SIP protocol for the
intercom – IP PBX is used in the network and the device is to be
registered to it and call through it.
(Read-only) The SIP number the device is registered with.
Technically, its Intercom Phone Numbers (ID) as configured in
the device.
Enter the Intercom API URL to start the service on. Example:
https://192.168.170.151/
The user name for the REST client to use for authentication.
This setting must match the API setting in the device.
The password for the REST client to use for authentication.
This setting must match the API setting in the device.
Endpoint/Master station. Master station supports 2N® IP Phone
D7A devices. The rest of the devices should be considered as
endpoints.
Basic/Digest/None as per Intercom’s configuration.
Enter the DTMF code that will be used to open the C•CURE door
associated on the triggers tab. Only applicable for 2N Devices.
This Code must match with “Switch Code” in 2N intercom
configuration and “Unlock PIN” in 2N Master Station
configuration.
Enter the workstation PC name as described in the workstations
of C•CURE that the device is associated with. Only applicable for
master stations.
To Next Page
