Mode Switching with 1-Button Models
Connect to the power supply (or, disconnect and reconnect it if already 2N IP Vario
®
connected).In case your device is equipped with 1 button, you can switch 2N IP Vario
®
the modes using one button only.
Wait for the first acoustic signal .
Press the quick dial button 15 times.
The acoustic signal indicates mode switching.
Wait until the device is restarted automatically.
Switching between static and dynamic IP address
Note
The 15 times 1 sequence must be entered within 30 seconds after the
first sound signal for security reasons. The inter-digit delay may be 2 s at
most.
The static IP address mode will be switched into the dynamic IP address mode and
vice versa upon restart.
To Next Page
Loading...
