Others
– select receiving SIP Receive SIP from any IP address (not only from SIP Proxy)
messages from addresses other than SIP Proxy. Used for direct calling to an IP
address, for example.
– allow sending 200 OK and BYE Send 200 OK and Bye after call rejection
messages after call rejection. It is a specific setting. The call is then identified as
received and immediately terminated on the Proxy. Normally, the call is rejected
with cause "404 Not Found".
– set the incoming call answer Answer incoming call automatically 2N SIP Mic
®
type:
– does not answer incoming calls automatically. Receive No 2N SIP Mic
®
the call manually.
– answer incoming calls immediately automatically.Yes 2N SIP Mic
®
– receives incoming calls in x seconds For x seconds 2N SIP Mic
®
automatically. Set a value in the range of 1–3600. The maximum ringing
time is not applied in this case.
– set the maximum call setup and ringing time in which Maximum ringing time
outgoing calls are terminated automatically. Set a value in the range of 1–3600.
This parameter is applied only if the preceding parameter is set to No.
To Next Page
Loading...