2N Sip mic - Outgoing Call; Outgoing Call ALARM

2N TELEKOMUNIKACE a.s., www.2n.cz 43/76
Outgoing Call
Destination – set the destination (phone number or IP URI) to which the call shall
be directed via SIP Proxy.
– set the call connection beep for . This Call connection beep 2N SIP Mic
®
selection is inactive by default.
– activate the relay at call connection. This Active relay at call connection
selection is inactive by default.
Outgoing Call ALARM
Destination – set the destination (phone number or IP URI) to which the call shall
be directed via SIP Proxy.
– enter the DTMF code to be sent from after call connection. DTMF 2N SIP Mic
®
Not completed by default.
– select a voice message to be played at call Select voice announcement
connection. No voice message is selected by default.
– select automatic retry after call rejection. Automatic retry after call rejection
The selection is inactive by default.
– set the count of call setup retries after call rejection: 0 to 30. Retry count
The default value is 0.
– set the timeout in seconds for call setup retries: 0 to 30. Retry timeout
The default value is 10 s.