5.10 [21 Hook Act] How To Modify Hook Value
Before to start the procedure of pressure calibration its required that the user insert the data of the hook.
PROCEDURES STATUS
IN THE CONTROL AREA
Follow steps in 3.5 paragraph to select and enter the menu parameters
Pressing the
keys, seek the page as shown on the right.
Press to get in.
A 78 L 8.1 W 1.2
21 Hook Act: .0
Press to move the asterisk ; by to modify the value
*
21 HookAct .0
Press to confirm the data and back at the previous page.
To Next Page
