5.7 [16 Boom Trasd] Length Calibration
This operation consists in the automatic self calibration of the Boom Length measured from cable reel.
Note!
Maximum and Minimum Length Position is defined by the machine constructor and it also depends by the machine type
and model. Values are already entered by the constructor! No changes are possible in this section!
PROCEDURES STATUS
IN THE CONTROL AREA
Follow steps in 3.5 paragraph to select and enter the menu parameters
Pressing the
keys, seek the page as shown on the right.
Press to get in.
A x.x L x.x W x.x
16 Boom Trasd.
Memorizing Minimum Length
Press keys to visualize Memo Min section.
Press
to enter.
L: x.x
Memo Min 0
Follow Instruction on display.
Press
button to confirm.
Press
button to turn back.
A: xx.x t xxxx
Esc to confirm
Memorizing Maximum Length
Press keys to visualize Memo Max section.
Press
to enter.
A: .x t 0
Memo Max 0
Follow Instruction on display.
Press
button to confirm.
Press
button to turn back.
A: xx.x t xxxx
Esc to confirm
To Next Page
Loading...
