5.6 [15 Angle Trasd] Angle Calibration
This operation consists in the automatic self calibration of the Boom Angle.
PROCEDURES STATUS
IN THE CONTROL AREA
Follow steps in 3.5 paragraph to select and enter the menu parameters
Pressing the
keys, seek the page as shown on the right.
Press to get in.
A x.x L x.x W x.x
15 Angle Trasd.
Minimum Angle Position.
Press keys to visualize Minimum Angle.
Press
to enter in the Modification Section.
A: .x t 0
Min 0
With the
button, take the asterisk on the numerical value and modify it with
the
keys.
To confirm , press .
*
Min 0
Note!
Default value of Minimum Angle Position is 0°.
Memorizing Minimum Angle
Press keys to visualize Memo Min section.
Press
to enter.
A: .x t 0
Memo Min 0
Follow Instruction on display.
Press
button to confirm.
Press
button to turn back.
A: xx.x t xxxx
Esc to confirm
Maximum Angle Position
To Next Page
Loading...
