If you confirm this operation ,the previous pressure table will delete.
If the system allow the action, the system will go immediately to the next step.
”CLOSE MAIN BOOM”: close all boom section.
”ENTER TO START”: press to Start next step.
if the system allow the action, the system will go immediately to the next step.
Close Main Boom
ENTER TO START
“Move A1 at 50” : move the boom until the angle 80 degree;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move A1 at 50
ENTER TO START
“Move B1 at 0%” : “B1” is the boom section number. Move the boom until
the indicated percentage;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move B1 at 0%
ENTER TO START
“Move B1 at 10%” : “B1” is the boom section number. Move the boom until
the indicated percentage;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move B1 at 10%
ENTER TO START
“Move B1 at 25%” : “B1” is the boom section number. Move the boom until
the indicated percentage;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move B1 at 25%
ENTER TO START
“Move B1 at 50%” : “B1” is the boom section number. Move the boom until
the indicated percentage;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move B1 at 50%
ENTER TO START
“Move B1 at 75%” : “B1” is the boom section number. Move the boom until
the indicated percentage;
”ENTER TO START” : press key to continue.
If the system allow the action, the system will go immediately to the next step.
Move B1 at 75%
ENTER TO START
To Next Page
Loading...
