2nd PASSWORD, enabling a higher access level, is dedicated to the Authorised Personnel.
The following menus are enabled:
•
••
• 32 Config. Customer Configuration Setting: Language / Measure System Selection
•
••
• 33 Tools Accessories Activation
•
••
• 15 Angle Trasd Angle Calibration
•
••
• 16 Boom Trasd Length Calibration
•
••
• 01 Save Save Parameters
•
••
• 26 Init Weight Weight Initialisation
•
••
• 21 Hook Act How To Modify Hook Value
•
••
• 31 E Mom Static Static Pressure Calibration
or
31 E Mom Dynamic Dynamic Pressure Calibration
•
••
• 31 COG Mode Centroids Memorization
•
••
• 27 Calibration Weight Calibration
•
••
• 28 W. Dynamic Weight Dynamic Compensation
•
••
• 10 Initialise Initialise Operative Mode
•
••
• 25 Save to All Calibration Copying From Mode 1 To Mode 2
•
••
• 01 Save Calibration Save Parameters And Calibration
•
••
• 30 Parameters Parameters Visualization And Modification
•
••
• 53 Init BlackBox Black Box Initialisation
•
••
• 50 Black Box Black Box Recorded Infos
•
••
• 52 Time Setting Time Settings
3rd PASSWORD is reserved to the programming staff.
•
••
• Some visualizations of the diagnostic are however enabled without password.
•
••
• Both the first two passwords may be programmed directly by the manufacturer.
•
••
• The load charts are written on EXCEL® sheet, filled and written in the EPROM with specific.
•
••
• Macro commands directly by the Manufacturer.
•
••
• All the messages for the operator, including the type of accessories mounted, are visualized in 4
languages selectable during the testing.
To Next Page
