EasyManua.ls Logo

3Com 2924-PWR - Page 68

3Com 2924-PWR
248 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
68 CHAPTER 4: MANAGING DEVICE SECURITY
For example, if the source MAC address is E0:3B:4A:C2:CA:E2 and the
wildcard mask is 00:00:00:00:00:FF, the first five bytes of the MAC are
used, while the last byte is ignored. For the source MAC address
E0:3B:4A:C2:CA:E2, this wildcard mask matches all MAC addresses in
the range E0:3B:4A:C2:CA:00 to E0:3B:4A:C2:CA:FF.
Destination MAC Address — Matches the destination MAC address
to which packets are addressed to the rule.
Destination Mask — Defines the destination MAC Address wildcard
mask. Wildcards are used to mask all or part of a destination MAC
address. Wildcard masks specify which bits are used and which are
ignored. A wildcard mask of FF:FF:FF:FF:FF indicates that no bit is
important. A wildcard mask of 00.00.00.00.00.00 indicates that all
bits are important. For example, if the destination MAC address is
E0:3B:4A:C2:CA:E2 and the wildcard mask is 00:00:00:00:00:FF, the
first five bytes of the MAC are used, while the last byte is ignored. For
the destination MAC address E0:3B:4A:C2:CA:E2, this wildcard mask
matches all MAC addresses in the range E0:3B:4A:C2:CA:00 to
E0:3B:4A:C2:CA:FF.
VLAN ID — Matches the packet's VLAN ID to the rule. The possible
field values are 1 to 4093.
CoS — Classifies traffic based on the CoS tag value.
CoS Mask — Defines the CoS mask used to classify network traffic.
Ethertype — Defines an identifier that differentiates between various
types of protocols.
Action — Selects the ACL forwarding action. In addition, the port can
be shut down, a trap can be sent to the network administrator, or
packet is assigned rate limiting restrictions for forwarding. The options
are as follows:
Permit — Forwards packets which meet the ACL criteria.
Deny — Drops packets which meet the ACL criteria.
Shutdown — Drops packet that meets the ACL criteria, and
disables the port to which the packet was addressed. Ports are
reactivated from the
Port Administration Setup Page.
2 Define the fields.
3 Click . The MAC-based ACL rule settings are modified, and the
device is updated.

Table of Contents

Related product manuals