3Com 3CBLSG48 - Removing ARP Entries

CHAPTER 9: CONFIGURING IP AND MAC ADDRESS INFORMATION
121
The ARP Settings Remove Page provides parameters for removing ARP
entries from the ARP Table.
The monitor user has no access to this page.
To remove ARP entries:
1 Click Administration > IP Addressing > ARP Settings >
Remove. The ARP Settings Remove Page opens.
Figure 63 ARP Settings Remove Page
Removing ARP
Entries
The ARP Settings Remove Page contains the following fields:
Clear ARP Table Entries — Specifies the types of ARP entries that
are cleared. The possible values are:
None — Maintains the ARP entries.
All — Clears all ARP entries.
Dynamic — Clears only dynamic ARP entries.
Static — Clears only static ARP entries.