3Com 3CBLSG48 - Removing Address Table Ports

CHAPTER 9: CONFIGURING IP AND MAC ADDRESS INFORMATION
129
Removing Address
Table Ports
The Port Remove Page allows the network manager to remove ports
from the address tables.
The monitor users have no access to this page.
To remove ports:
1 Click Monitoring > Address Tables > Port Remove. The Port
Remove Page opens.
Figure 68 Port Remove Page
The Port Remove Page contains the following fields:
Select a Port — Displays the current port settings.
MAC Address — Displays the current MAC addresses listed in the
MAC address table.
VLAN ID — Displays the VLAN ID attached to the MAC Address.
State — Displays the MAC address configuration method. Possible
values are:
 Static — Indicates the MAC address is statically configured.
 Dynamic — Indicates the MAC address is dynamically
configured.
Port Index — Indicates Port Table number.