3Com 3CBLSG48 - Defining Spanning Tree

CHAPTER11: CONFIGURING SPANNING TREE
138
Priority — Priority value of the port. The priority value influences
the port choice when a bridge has two ports connected in a loop.
The priority range is between 0 -240.
Network administrators can assign STP settings to specific interfaces
using the Spanning Tree Setup Page.
The monitor user has no access to this page.
To configure Spanning Tree Setup:
1 Click Device > Spanning Tree > Setup. The Spanning Tree Setup
Page opens.
Figure 72 Spanning Tree Setup Page
Defining Spanning
Tree
The Spanning Tree Setup Page contains the following fields:
Status — Indicates whether STP or RSTP is enabled on the device.
The possible field values are:
Enabled — Enables STP or RSTP on the device.
Disabled — Disables STP and RSTP on the device.