3Com 3CBLSG48 - Defining Port Settings

CHAPTER 6: CONFIGURING PORTS
93
The Port Administration Setup Page allows network managers to
configure port parameters for specific ports.
Monitor users have no access to this page.
To configure Port Settings:
1 Click Port > Administration > Setup. The Port Administration
Setup Page opens.
Figure 44 Port Administration Setup Page
Defining Port
Settings
The Port Administration Setup Page contains the following fields:
Port State — Defines the port state. The possible values are:
No Change — Retains the current port status.
Enabled — Enables the port.
Disabled — Disables the port.
Flow Control — Displays the flow control status on the port.
Operates when the port is in full duplex mode. The possible field
values are:
Enabled — Enables flow control on the port.
Disabled — Disables flow control on the port.
No Change — Retains the current flow control status on port.