CHAPTER 6: CONFIGURING PORTS
92
Speed — Displays the configured rate for the port. The port
type determines what speed setting options are available. Port
speeds can only be configured when auto-negotiation is disabled.
The possible field values are:
10M — Indicates the port is currently operating at 10 Mbps.
100M — Indicates the port is currently operating at 100 Mbps.
1000M — Indicates the port is currently operating at 1000 Mbps.
Auto — Indicates the port speed is configured to auto-negotiation.
Duplex — Displays the port duplex mode. This field is
configurable only when auto-negotiation is disabled, and the port
speed is set to 10M or 100M or 1000M per second. This field cannot
be configured on LAGs. The possible field values are:
Full — The interface supports transmission between the device
and its link partner in both directions simultaneously.
Half — The interface supports transmission between the device
and the client in only one direction at a time.
Auto — Indicates the port duplex is configured to
auto-negotiation.
PVID — Displays the VLAN ID for the indicated port. The port will
apply this VLAN ID to any untagged packet it receives
To Next Page
Loading...
