CHAPTER 6: CONFIGURING PORTS
94
Speed — Defines the configured rate for the port. The port speed
determines what speed setting options are available. Port speeds
can only be configured when auto negotiation is disabled. The
possible field values are:
10 — Indicates the port is currently operating at 10 Mbps.
100 — Indicates the port is currently operating at 100 Mbps.
1000 — Indicates the port is currently operating at 1000 Mbps.
Auto — Use to automatically configure the port.
No Change — Retains the current port speed.
Duplex — Defines the port duplex mode. This field is configurable
only when auto-negotiation is disabled. This field cannot be
configured on LAGs. The possible field values are:
Auto — Use to automatically configure the port.
Full — The interface supports transmission between the device
and its link partner in both directions simultaneously.
Half — The interface supports transmission between the device
and the client in only one direction at a time.
No Change — Retains the current port duplex mode.
Select Ports — Indicates the ports to be configured.
Select All — Allows the user to assign the settings to all ports.
Select None — Removes the ports selected.
2 Define the fields.
3 Click Apply. The ports setting are applied, and the device is
updated.
To Next Page
Loading...
