117
The Port Administration Setup Page contains the following fields:
■ Port State — Specifies the port state. The possible values are:
■ Enabled — Enables the port.
■ Disabled — Disables the port.
■ No Change — Retains the current port status.
■ Flow Control — Specifies the flow control status on the port.
Operates when the port is in full duplex mode. The possible field
values are:
■ Enabled — Enables flow control on the port.
■ Disabled — Disables flow control on the port.
■ No Change — Retains the current flow control status on port.
■ Speed — Specifies the configured rate for the port. The port type
determines what speed setting options are available. The possible field
values are:
■ 10 — Indicates the port is currently operating at 10 Mbps.
■ 100 — Indicates the port is currently operating at 100 Mbps.
■ 1000 — Indicates the port is currently operating at 1000 Mbps.
■ Auto — Use to automatically configure the port.
■ No Change — Retains the current port speed.
■ Duplex — Specifies the port duplex mode. This field is configurable
only when the port speed is set to 10M or 100M. The possible field
values are:
■ Full — The interface supports transmission between the device and
its link partner in both directions simultaneously.
■ Half — The interface supports transmission between the device
and the client in only one direction at a time.
■ Auto — Use to automatically configure the port.
■ No Change — Retains the current port duplex mode.
■ Select Ports — Selects the ports to be configured.
2 Define the configuration fields.
3 Select the ports to which these settings will be applied.
4 Click . The ports are configured, and the device is updated.
To Next Page
Loading...
