119
■ Speed — Displays the configured rate for the port. The port type
determines what speed setting options are available. The possible field
values are:
■ 10 — Indicates the port is currently operating at 10 Mbps.
■ 100 — Indicates the port is currently operating at 100 Mbps.
■ 1000 — Indicates the port is currently operating at 1000 Mbps.
■ Auto — Used to automatically configure the port.
■ PVID — VLAN ID assigned to untagged frames received on this port.
■ Link Type — Displays the VLAN membership mode for a port. The
possible field values are:
■ Access — The port transmits and receives untagged frames only.
■ Hybrid — The port may transmit tagged or untagged frames.
■ Trunk — The port is an end-point for a VLAN trunk. A VLAN trunk
is a direct link between two switches, so the port transmits tagged
frames that identify the source VLAN.
■ Duplex — Displays the port duplex mode. This field is configurable
only when the port speed is set to 10M or 100M. This field cannot be
configured on LAGs. The possible field values are:
■ Full — The interface supports transmission between the device and
its link partner in both directions simultaneously.
■ Half — The interface supports transmission between the device
and the client in only one direction at a time.
■ Auto — Use to automatically configure the port.
To Next Page
Loading...
