Using the Command Line Interface (CLI) 29
4 At the password prompt, press Return.If you have logged on correctly,
the Console# prompt is displayed.
5 Enter show ip interface to view a summary of the allocated IP address.
The following is an example of the displayed information.
Console#show ip interface
IP Address and Netmask: 169.254.99.51 255.255.0.0 on VLAN 1,
Address Mode: DHCP
Console#
The initial set up of your switch is now complete and the switch is ready
for you to set up your chosen management method. See
“Methods of
Managing a Switch” on page 21.
For more information about the CLI, refer to the 3Com CLI Reference
Guide.
If you do not intend to use the command line interface using the console
port to manage the switch, you can log out, disconnect the serial cable
and close the terminal emulator software.
To Next Page
Loading...
