3Com 4200G 12-Port - Page 45

5-8
Table 5-1 lists the CLI views provided by the 3com switch 4200G, operations that can be performed in
different CLI views and the commands used to enter specific CLI views.
Table 5-1 CLI views
View Available operation Prompt example Enter method Quit method
User view
Display operation
status and statistical
information of the
switch
<Sysname>
Enter user view
once logging into
the switch.
Execute the quit
command to log
out of the switch.
System view
Configure system
parameters
[Sysname]
Execute the
system-view
command in user
view.
Execute the quit
or return
command to
return to user
view.
1000 Mbps
Ethernet port
view:
[Sysname-Gigabi
tEthernet1/0/1]
Execute the
interface
gigabitethernet
command in
system view.
Ethernet port
view
Configure Ethernet
port parameters
10 Gigabit
Ethernet port
view:
[Sysname-TenGi
gabitEthernet1/1/
1]
Execute the
interface
tengigabitethern
et command in
system view.
Aux1/0/0 port
(the console
port) view
The 3com switch
4200G does not
support configuration
on port Aux1/0/0
[Sysname-Aux1/
0/0]
Execute the
interface aux
1/0/0 command in
system view
VLAN view
Configure VLAN
parameters
[Sysname-vlan1]
Execute the vlan
command in
system view.
VLAN
interface view
Configure VLAN
interface
parameters,
including the
management VLAN
parameters
[Sysname-Vlan-i
nterface1]
Execute the
interface
Vlan-interface
command in
system view.
Loopback
interface view
Configure loopback
interface parameters
[Sysname-LoopB
ack0]
Execute the
interface
loopback
command in
system view.
NULL
interface view
Configure NULL
interface parameters
[Sysname-NULL
0]
Execute the
interface null
command in
system view.
Local user
view
Configure local user
parameters
[Sysname-luser-u
ser1]
Execute the
local-user
command in
system view.
Execute the quit
command to
return to system
view.
Execute the
return
command to
return to user
view.