1-5
Follow these steps to configure ICMP test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
Enable the remote-ping
client function
remote-ping-agent enable
Required
By default, the remote-ping client
function is disabled.
Create a remote-ping
test group and enter its
view
remote-ping
administrator-name
operation-tag
Required
By default, no test group is configured.
Configure the
destination IP address
destination-ip ip-address
Required
By default, no destination address is
configured.
Configure the source IP
address
source-ip ip-address
Optional
By default, no source IP address is
configured.
Configure the test type
test-type icmp
Optional
By default, the test type is ICMP.
Configure the number
of probes per test
count times
Optional
By default, each test makes one probe.
Configure the packet
size
datasize size
Optional
By default, the packet size is 56 bytes.
Configure the
maximum number of
history records that can
be saved
history-records number
Optional
By default, the maximum number is 50.
Configure the
automatic test interval
frequency interval
Optional
By default, the automatic test interval is
zero seconds, indicating no automatic
test will be made.
Configure the probe
timeout time
timeout time
Optional
By default, a probe times out in three
seconds.
Configure the type of
service (ToS)
tos value
Optional
By default, the service type is zero.
Start the test
test-enable
Required
Display test results
display remote-ping results
[ admin-name operation-tag ]
Required
Available in any view.
2) Configuring DHCP test on remote-ping client
Follow these steps to configure DHCP test on remote-ping client:
To do… Use the command… Remarks
Enter system view
system-view
—
To Next Page
Loading...
