7
ENGLISH
Preventive inspection before use of the system
CAUTION
Please examine the TRIOS IOS system for any mechanical
damage on:
• all enclosures,
• all cables.
Safety can only be guaranteed if NO DAMAGE
on the TRIOS IOS system is observed.
Modifications of the system
CAUTION
Modifications of the system which may affect the safety of
the operator, patients or third parties are prohibited by law!
Approved software only
CAUTION
Install only approved software – to prevent interference
with the runtime reliability of the system and programs
within it.
Proper training
WARNING
Before you attempt to use the TRIOS scanner equipment
with patients:
• You should be trained to use the system and have read
and understood all sections of this guide describing
correct operation.
• You should also be thoroughly familiar with the safe
operation of the TRIOS scanner equipment as described
in this documentation.
In case of equipment failure
WARNING
If at any time the TRIOS IOS system malfunctions,
or if you suspect in any way that the TRIOS system
is not working correctly:
• Remove the scanner from contact with the patient.
• Unplug the system and make sure it cannot be used
before it is checked.
• Contact your reseller.
• Do not attempt to open any covers on the TRIOS IOS system.
Wireless Connection
The wireless scanner is intended to be used indoors.
CAUTION
The wireless scanner could interfere with other portable
and mobile RF communication equipment.
5.2 Mechanical Hazards
For S2P (Pod) only:
WARNING
• Always place the scanner in its intended mount on the
pod when not in use.
• Do not place the pod on a slope greater than 5 degrees
Fragile and movable parts
WARNING
Be careful to avoid the following potential sources of injury:
• Do not lean or sit on any part of the system.
• Movable parts can pinch body parts.
Dropped or damaged equipment
WARNING
If you drop a TRIOS tip on the floor, you MUST dispose of it
immediately and NOT use the same tip again for scanning.
There is high risk that the mirror in the tip has become
dislodged and can fall out.
WARNING
If the handheld scanner is dropped or bumped it should
immediately be calibrated before further use. If calibration
fails, please contact your technical service provider.
See this guides instructions on calibrating the handheld
scanner.
WARNING
If the handheld scanner is dropped, examine the TRIOS IOS
system for any mechanical damage. If a mechanical damage
is observed or suspected, treat this as an equipment failure
(see this guide’s instructions on handling equipment failures).
WARNING
If a battery is dropped, examine it for any mechanical
damage. If a mechanical damage is observed or suspected,
the battery must be disposed of in the correct manner.
System S2A (MOVE/MOVE+ cart) only
WARNING
• Keep both hands on the upper part of the MOVE/MOVE+
cart when moving it across the floor.
• Do not attempt to lift the MOVE/MOVE+ cart alone. When
moving the system over a door step or other unsmooth
surface, get assistance from another person to ensure stability.
• When moving the MOVE/MOVE+ cart across the floor,
maintain all its wheels in contact with the floor and
ensure that they are not locked.
• Always place the scanner in its intended mount on the
MOVE/MOVE+ cart when not in use and when moving
the MOVE/MOVE+ cart.
• Keep your feet clear of the MOVE/MOVE+ cart’s base and
wheels when moving the MOVE/MOVE+ cart.
• Never drag the MOVE/MOVE+ cart across any of its cables.
• Do not place the MOVE/MOVE+ cart on a slope greater
than 10 degrees.
• Keep sharp objects away from the touch screen.
To Next Page
Loading...
