4IPNET EAP200 - 2.5 Console Interface

User’s Manual
User’s ManualUser’s Manual
User’s Manual
EAP200
EAP200EAP200
EAP200 Enterprise Access Point ENGLISH
11
Copyright © 4IPNET, INC.
2.5 Console Interface
Via this port to enter the console interface for the administrator to check the IP address of EAP200 and reset
the device to default if the admin password is forgotten.
1. In order to connect to the console port of EAP200, a console, modem cable and a terminal simulation
program, such as the Hyper Terminal are needed.
2. If a Hyper Terminal is used, please set the parameters as 115200, 8, None, 1, None.
The console interface looks like the screenshot below, displaying the current LAN IP address and the
instructions to reset device to default.