4IPNET EAP200 - 2.6 Access Web Management Interface

User’s Manual
User’s ManualUser’s Manual
User’s Manual
EAP200
EAP200EAP200
EAP200 Enterprise Access Point ENGLISH
13
Copyright © 4IPNET, INC.
2.6 Access Web Management Interface
4ipnet EAP200 supports web-based configuration. Upon the completion of hardware installation, EAP200
can be configured through a PC by using its web browser such as Mozilla Firefox 2.0 (and higher) or Internet
Explorer version 6.0 (and higher).
The default values of the EAP200’s LAN IP Address and Subnet Mask are:
IP Address: 192.168.1.1
Subnet Mask: 255.255.255.0
Example of entering EAP200's default IP Address into a web browser
• To access the web management interface (WMI), connect the administrator PC to the LAN port of
EAP200 via an Ethernet cable. Then, set a static IP Address on the same subnet mask as the
EAP200 in TCP/IP settings of your PC, such as the following example:
IP Address: 192.168.1.100
Subnet Mask: 255.255.255.0
 Note:
Please note that the IP Address used should not overlap with the IP Addresses of
any other device within the same network.
• Launch the web browser on your PC and enter the IP Address of the EAP200 (192.168.1.1) at the
address field, and then press Enter. The following Administrator Login Page will then appear. Enter
“admin” for both the Username and Password fields, and then click Login.
Administrator Login Page