Desired Sample Size
1. Three
UNIT WEIGHT BY
LED’s should be blinking at this
point, if not, press the
RESET
key to clear any unit weight.
lf you are going to use a tare container, place it on the weighing
pan.
2. Press the
SAMPLE
key.
Any tare container will be
automatically tared.
The display will show
“
Add Sample
” and “10 pcs”.
3. Use the
0
Æ
9
10-key pad to
display the sample size desired.
If you hit the wrong key, press
the
C
key to clear and start
again. (Example of selecting a
sample size of 20)
4. Place the selected number of
sample pieces on the weighing
pan (or in the tared container).
The weight of the pieces will be
displayed.
5. Press the
ENTER
key.
The display will show “-------”
for a moment while calculating
the unit weight.
After a moment the display will
show the count, total weight and
unit weight.
If the “
Add Sample
” display appears again,
then the sample size is not large enough for
accurate counting – add the additional number
of sample pieces.
8888820
81
6. You may now begin counting operations for
pieces of the same weight.
pcs
W2WEIGHT (kg)
12134567892.220
2A3SAMUUW (g)
12314567111.000
ÑBlinkingÒ
0 Æ 9
8888820
81
pcs
W2WEIGHT (kg)
11234567890.000
A
23Add Sample
123456789012345678901234567
TUV
DEFABC
MNO
6
1
78
PQRS
23
JKLGHI
09
WXYZ
4
#
5
C
.
8888820
81
pcs
W2WEIGHT (kg)
11234567892.220
A
23Add Sample
123456789012345678901234567
SAMPLE
8888810
81
pcs
W2WEIGHT (kg)
11234567890.000
A
23Add Sample
12345678901234567
-------
81
pcs
W2WEIGHT (kg)
1213456-------
A
23Add Sample
123456789012345678901234567
ENTER
If weight isn’t zero, press TARE.
15
To Next Page
Loading...
