Hardware Installation
Figure 26 Mounting the Earth Bar
1. Slide the four bar nuts (A) into the slot at the top and bottom of each
cabinet, Page 41 .
2. Install the two earthing bars (B) with screws (C) using a wrench, Page 41 .
3. Install the earth bars between each cabinet at the top and bottom.
4. Verify that the torque of all mounting screws is set to 10 Nm
+
/- 0.5 Nm.
4.4 Installing Supporting Captive Nuts
Supporting captive nuts are used to secure hardware units to the metal rack
inside the cabinet. Insert the captive nuts in the square cabinet holes, Page 42 .
41
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...