Installing MX-ONE
Figure 47 Installing the Board Cover
Note: The board cover must be installed to fulfill the EMC requirement.
1 Fasten the finger plate (B) using four screws (D), Page 64 .
2 Fasten the board cover (A) above the finger plate using four screws (D) on
the top part, and the two screws (C) on the bottom part, Page 64 .
3 Install board cover on the other subrack in the same way.
4.9 Installing the Fan Unit
This section describes the installation of fan unit and upper air plate in the
cabinet.
Note: If only one subrack is to be installed the fan unit must be strapped for
being fed from only one DC/DC converter.
64
6/1531-ASP 113 01 Uen J2 2008-07-17
To Next Page
Loading...