107
be driven in normal conditions, the
system is not available.
When the conditions disabling the
system functions end, it will return to
normal and complete operation. Should
the fault persist, contact a Dealership.
System Fault Message
If the system switches off and a
dedicated message is shown on the
display, it means that there is a fault on
the system.
In this case, it is still possible to drive
the car, but you are advised to contact
a Dealership as soon as possible.
Driving in special conditions
In certain driving conditions, such as,
for example:
driving close to a bend;
vehicles with small dimensions
and/or not aligned in the driving lane;
lane change by other vehicles;
vehicles travelling at right angles to
the vehicle.
System intervention might be
unexpected or delayed. The driver
must therefore be very careful, keeping
control of the car to drive in complete
safety.
WARNING In particularly complex
traffic conditions, the driver can
deactivate the system manually through
the Uconnect™ system or the
instrument panel.
Driving close to a bend
When entering or leaving a wide bend,
the system may detect a car that is in
front of you, but that is not driving in
the same lane fig. 101. In cases such
as these, the system may intervene.
101 F0S0771
Vehicles with small dimensions
and/or not aligned in the driving
lane
The system cannot detect cars in front
of the car but outside the field of vision
of the camera and may therefore not
react in the presence of small cars,
such as motorbikes. fig. 102.
102 F0S0772
Pedestrian/cyclist detection
While driving, when there is a risk of
collision with a pedestrian or cyclist, the
system will display the relevant warning
message indicating the direction of
obstacle detection and, if necessary,
apply the brakes.
Lane change by other vehicles
cars suddenly changing lane, entering
the same lane as your car and this
moving into the camera's field of vision,
may cause the system to intervene
fig. 103.
To Next Page
Loading...
