Abarth 500e - Ecoasting Mode (ENERGY SAVING)

185
To switch to immediate charging mode
during scheduled charging:
if charging is in progress, interrupt
the scheduled charging first (see
chapter "Interrupting charging");
activate immediate recharging by
pressing the button again (A) fig. 180
on the port.
INTERRUPTING
CHARGING
The charging cable is blocked when
charging is in progress. To interrupt the
charging process, unlock the doors
with the key and press the button (A)
fig. 180 on the port. The charging
process will be interrupted and you can
disconnect the charging cable. When
immediate recharging is interrupted
and there is no charging scheduled
(see the "Charging schedule" chapter),
the LEDs (B) fig. 179 will light up with a
steady green light showing the current
battery charge level; if there are any
upcoming charging schedules, the
LEDs (B) fig. 179 will glow blue light
and the LED will light up (A) fig. 179.
If a charging interval is interrupted, the
same interval can only be resumed by
disconnecting and reconnecting the
charging cable, otherwise charging will
continue with subsequent schedule.
DISCONNECTING THE
CHARGING CABLE
The charging cable is locked during
charging or when the doors are locked.
To disconnect the charging cable,
interrupt the charging in progress (see
the "Interrupting charging" paragraph).
If no charging is in progress, first
unlock the doors using the button
on the key and then disconnect the
charging cable.
COMPLETION OF
CHARGE
The full charging procedure, if not
interrupted, ends when all LEDs (A)
fig. 181 they light up with a steady
green light.
181 F0S1178
FAILURE DURING
CHARGING PROCEDURE
If a fault is detected during the charging
procedure first and last LED (A) fig. 182
located next to the charging port will
light up flashing red.
182 F0S1209
"eCoasting" mode
(ENERGY SAVING)
This is a mode that replaces the
exhaust brake when the accelerator
pedal is released, recovers energy
during the slowing down phase of the
car.
The "eCoasting" mode is automatically
activated in "SCORPION TRACK"
operating mode to maximise energy
recovery when the accelerator and
brake pedals are released.
Driving in "eCoasting" mode is possible
if the transmission is in position "D"
(Drive).