Abarth 500e - Roof

KNOWING YOUR CAR
56
This device is also useful if the windows
are activated accidentally by children
on board the car.
The anti-pinch safety function is
activated both during the manual and
the automatic operation of the window.
When the anti-pinch device is activated
the window travel is immediately
interrupted. Then the window stroke is
automatically inverted.
29)
ELECTRIC WINDOWS
SYSTEM INITIALISATION
If power supply is interrupted when
the window is moving, the electric
window automatic operation must be
reinitialised. The initialisation procedure
described below must be carried out
with the doors closed and for each
door:
fully close the window to be
initialised, with manual operation;
after the window has reached the
upper end of travel, hold the up button
down for at least 3 seconds.
WARNING
27) Improper use of the electric windows
can be dangerous. Before and during their
operation, ensure that any passengers are
not at risk from the moving glass either
by personal objects getting caught in the
mechanism or by being hit by it directly.
28) When leaving the car, always set the
ignition device in the STOP position and
take the electronic key with you to avoid
the risk of injury of people still on board
due to accidental operation of the power
windows.
29) If the anti-pinch protection intervenes
three consecutive times in one minute or
is faulty, the automatic closing operation
of the window is inhibited, only allowing it
in "steps"; the button is released for the
subsequent manoeuvre. In order to restore
the correct operation of the system, the
respective window must be wound down.
ROOF
FIXED GLASS SUNROOF
(where provided)
The roof comprises a wide fixed
glass panel and a manually-operated
sunshade. The blind can be used in the
"all closed" or "all open" positions.
To open the blind, grab the handle,
press the tooth (A) fig. 53 and move it
to the completely open position.
To close it, grab the grip and move the
blind to the closed position until catch
(A) is attached.
A
53 F0S1269
SUNROOF
(where provided)
30)
12) 13) 14)
To move the sunshade, follow the
instructions in “fixed glass roof”.
Opening
Press button (A) located near the front
ceiling light pressed fig. 54, to move
the roof to “vent” position. With the roof
open in “vent” position, hold button (A)
pressed again to move the roof to all
open position.