43
stroke for each two strokes of the
windscreen wiper;
With the ring in position , the wiper
active and reverse gear engaged, the
wiper is activated in synchronous
mode.
With the ring in position , the rear
window wiper is stopped.
NOTE If automatic wiping mode is
active and the sensor does not detect
water, the rear window wiper will stays
still when the ring is turned to position
.
Push the stalk towards the dashboard
(rocking position) to activate the rear
window washer jet. Keep pushing
the lever to automatically activate
both the rear window washer jet and
the rear window wiper with a single
movement. Releasing the stalk will
activate three strokes, as described for
the windscreen wiper.
WARNING
25)
If the window needs to be cleaned,
make sure the device is turned off or the
ignition device is in the STOP position.
26)
Driving with worn windscreen/rear
window wiper blades is a serious risk,
because visibility is reduced in bad
weather.
IMPORTANT
8)
Never use the screen wiper to remove
layers of snow or ice from the windscreen
glass. In such conditions, the wiper
may be subjected to excessive stress
and the motor cut-out switch, which
prevents operation for a few seconds, may
intervene. If operation is not restored,
contact a Dealership.
9)
Do not operate the windscreen wiper
with the blades lifted from the windscreen.
10)
Do not activate the rain sensor when
washing the car in an automatic car wash.
11)
Make sure the device is switched off if
there is ice on the windscreen glass.
PROGRAMMING THE
CLIMATE CONTROL
SYSTEM
(where provided)
The system provides two types
of remote climate control system
programming:
timely start of the climate control
system: this can be activated through
the dedicated smartphone app (where
provided). Refer to the "Connected
Services - Uconnect Services" chapter
in the "Multimedia" section.
Programming the climate control
system with start time: This can be
activated either through the dedicated
smartphone app (where provided) or
by programming a start time using the
Uconnect™ system (see "ENGINE"
in the"Vehicle mode" paragraph of the
"Multimedia" section).
Failed climate control
system programming
messages
If the on-demand or programmed
climate control system switch-on fails
or ends early, dedicated messages will
be displayed on the instrument panel
display.
How to use the
climate control system
programming functions
Starting the climate control system
Select the programming function on
the dedicated app (where provided.
Refer to the "Multimedia" section).
The passenger compartment climate
control system will remain active for 15
minutes unless the ignition device is
pressed.
This function can be activated twice
after which it is necessary to turn the
ignition device to ENGINE to allow
turning on the climate control system
app (where provided) on-demand
again.
If the ambient temperature is lower
than 4.5 °C when the function is
started, the electric defrosters (heated
rear window, heated mirrors and
To Next Page
Loading...
