Abarth 500e - Page 69

KNOWING YOUR CAR
44
heated windscreen where fitted) are
also activated.
Programming the climate control
system with start time
Select a time to start climate control
system programming using the
Uconnect™ system or the dedicated
app (refer to the "Multimedia" section);
the passenger compartment climate
control system will remain active unless
the ignition device is pressed;
The on-demand starting and
programming of the climate control
system can be successful in the
following conditions:
Doors closed
Bonnet closed
Boot closed
Hazard lights not active
Alarm not active
Adequate 12V battery state of
charge
Ignition device in the STOP position
Transmission in P position
If the start on-demand function has
not been activated twice
If the key is not inside the car
(necessary condition for programming
the climate control system with start
time)
How to start climate control system
programming
Select the programming function on
the dedicated app (where provided.
Refer to the "Multimedia" section) to
start the climate control system on-
demand or select an climate control
system programming start time on the
Uconnect™ system or dedicated app
(refer to the "Multimedia" section).
The doors of the car will lock, the
climate control system programming
will start and the car will go into
ENGINE mode. If the climate control
system is started on-demand, the car
will remain in ENGINE mode for 15
minutes; if the climate control system is
programmed to start at a certain time,
the car will remain in ENGINE mode.
NOTES
In case of motor malfunction/fault,
the climate control system
programming will be disabled.
For safety reasons, both when the
climate control system is started on-
demand or programmed with start
time, the wipers are disabled when the
function is active. For safety reasons,
the windows are disabled when the
climate control system is started on-
demand.
In case of activation of the climate
control system on-demand, the sunroof
and soft top are also disabled.
Two 15-minute cycles of climate
control system operation are possible
after which the ignition device must
be turned to the ENGINE position to
perform new start cycles.
How to finish programming the
climate control system without
driving the car
If the climate control system starts
up on time, select the end of charging
function on the dedicated app (where
provided. Refer to the "Multimedia"
section) or wait for the end of the start
cycle (about 15 minutes).
In case of programming the climate
control system with start time, finish
charging through the programming
function on the dedicated app (where
provided. Refer to the "Multimedia"
section).
How to stop climate control system
programming and drive the car
Programming can be interrupted
with time or start the climate control
system on time by moving the ignition
device to the START position. A
dedicated message will appears on the
instrument panel.