EasyManua.ls Logo

Abarth 500e - Power Sources that Can be Used

Default Icon
314 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
STARTING AND DRIVING
160
154 F1A0725
AC (alternating current) charging at a
charging station ( 480 V RMS).
Symbol on the cable charging
connector (car side) for the Mode 4
cable and on the charging port flap
155 F1A0718
DC (direct current) charging at a
charging station (50500 V).
WARNING
150)
In order to reduce the risk of electric
shock or damage to the device, special
care should be taken when cleaning:
ALWAYS unplug the device from the
domestic power supply socket and car
ports.
IMPORTANT
49)
Do not charge if the external
temperature is -30°C or lower, as charging
is likely to take longer and the charging
device may be damaged.
50)
Do not leave the car or the charging
cable in areas where the external
temperature is below -40°C as they may
be damaged.
51)
In cold temperatures, the charging
cable may become stiff. Therefore, be
careful not to apply excessive force to the
charging cable as it may be damaged.
52)
Do not use personal generators to
charge the high-voltage battery. This may
cause fluctuations in charging and the
voltage may be insufficient, resulting in
damage to the car system.
53)
Charging the high-voltage battery
using incorrect or damaged sockets, or
charging cables and not following the
prescribed charging procedures may
cause short circuits, fire and potential risk
of damage to the electrical system of the
car.
54)
Avoid leaving the high-voltage battery
for several days with the charge indicator
at or near zero. The high-voltage battery
may be damaged.
55)
You do not need to wait until the high-
voltage battery level is low to recharge.
The performance of the high-voltage
battery is optimal when it is charged
regularly.
56)
Charging the high-voltage battery may
take longer if the temperature of the high-
voltage battery is high or low.
57)
During charging, especially with fast
charging, high-voltage battery cooling
components may be voltage activated.
Therefore, it is normal to hear noises
during this operation.
POWER SOURCES
THAT CAN BE USED
151) 152) 153) 154) 155) 156) 157) 158) 159) 160) 161)
162) 163) 164) 165) 166) 167) 168) 169) 170) 171) 172) 173)
174) 175) 176) 177)
GENERAL INFORMATION
The high-voltage battery of the car
can be charged using special charging
cables:
the connection of the charging port
located on the rear right side of the car
to the charging ports in public charging
stations;
or
to the domestic socket.
The charging procedure control
and monitoring takes place in a fully
automatic way.

Table of Contents

Other manuals for Abarth 500e