143
Each time button SET + is pressed the
set speed will be fine tuned.
Decreasing speed
With the device activated, the speed
can be decreased by pressing button
SET –.
Keeping the button pressed, the set
speed will decrease until the button is
released, then the new speed will be
stored.
Each time button SET – is pressed the
set speed will be fine tuned.
WARNING Pressing the button SET
+ (or SET –) the speed is adjusted
depending on the selected unit of
measurement ("metric" or "imperial")
set through the Menu of the instrument
panel display or, depending on the
versions, in the menu of Uconnect™
(see "Settings" in the "Vehicle mode"
paragraph in the "Multimedia" section).
WARNING On steeply sloping roads,
the system may not be able to maintain
the set speed, which may increase
the speed of the car. It is, therefore,
preferable to switch the device off
under these conditions. The device
keeps the speed stored even uphill and
downhill. A slight variation in the speed
on slight rises is completely normal.
RECALLING THE SPEED
With transmission operating in D
(Drive), press and release the RES
button to recall the previously set
speed.
DEACTIVATING THE
DEVICE
Pressing the CANC button or pressing
the brake pedal as the car is slowing
down deactivates the electronic Cruise
Control without deleting the stored
speed.
The Cruise Control can also be
deactivated if the electric parking
brake (EPB) is activated or if the
braking system intervenes (e.g. the
ESC system) or in other particular
conditions.
The stored speed is deleted in the
following cases:
pressing button or switching off
the motor;
if there is a malfunction in the
electronic Cruise Control.
DEACTIVATING THE
DEVICE
The electronic Cruise Control is
deactivated by pressing button or
bringing the ignition device switch to
STOP.
WARNING
143)
While driving with the device active,
never move the gear lever to neutral.
144)
In the event of device malfunction or
failure, contact a Dealership.
145)
The electronic Cruise Control can
be dangerous if the system cannot keep
a constant speed. In specific conditions
speed may be excessive, resulting in the
risk of losing control of the vehicle and
causing accidents. Do not use the device
in heavy traffic or on winding, icy, snowy or
slippery roads.
PARK ASSIST
SYSTEM
VERSIONS WITH 3
SENSORS
(where provided)
146)
38) 39) 40)
The parking sensors, located in the rear
bumper fig. 133, detect the presence
of any obstacles and warn the driver
about them, through an acoustic
warning and, where provided, visual
warnings on the instrument panel
display.
To Next Page
Loading...
