Abarth 500e - Head Restraints; Steering Wheel

KNOWING YOUR CAR
34
HEAD RESTRAINTS
19)
REAR
Upward adjustment (usage
condition): raise the head restraint
until it clicks into place.
Downward adjustment: press at the
same time buttons (A) fig. 31 at the
side of the two supports and lower the
head restraint.
31 AB0A0561
The particular shape of the head
restraint deliberately interferes with the
correct support of the rear passenger’s
back on the backrest in order to force
them to lift the head restraint for correct
use.
WARNING If the rear seats are used,
always set the head restraints in the
"completely raised" position.
Removal
To remove the rear head restraints
press buttons (A) fig. 31 at the side of
the two supports simultaneously and
lift them out upwards. The rear head
restraints must be lifted out with the
backrest released and tilted toward the
passenger compartment or with the
tailgate open.
WARNING
19) All adjustments must be carried out
only with the car stationary and motor
stopped. Head restraints must be adjusted
so that the head, rather than the neck,
rests on them. Only in this case they can
protect your head correctly.
STEERING WHEEL
20) 21)
ADJUSTMENTS
The steering wheel can be adjusted
both in height and in depth.
32 AB0A0515
To carry out the adjustment move the
lever (A) fig. 32 downwards in position
(1), then adjust the steering wheel to
the most suitable position and then
lock it in this position moving the lever
(A) again in position (2).
WARNING
20) All adjustments must be carried out
only with the car stationary and motor
stopped.
21) It is absolutely forbidden to carry
out any after-market operation involving
steering system or steering column
modifications (e.g.: installation of
anti-theft device) that could badly affect