Abarth 500e - Speed Limiter

141
SPEED LIMITER
(where provided)
DESCRIPTION
This device allows the speed of the car
to be limited to values which can be set
by the driver.
The maximum speed can be set both
with car stationary and in motion. The
minimum speed that can be set is
30 km/h.
When the device is active, the car
speed depends on the pressure
at the accelerator pedal, until the
programmed speed limit is reached
(see "Speed limit programming"
paragraph).
ACTIVATING THE DEVICE
To activate the device press button (A)
on the steering wheel fig. 131.
131 AB0A0494
When the device is enabled, it is
indicated by the "LIM" symbol being
shown on the display along with the
last speed set.
If the electronic Cruise Control or
Adaptive Cruise Control has been
activated previously, button (A) fig. 131
must be pressed twice. The first press
switches off the function activated
previously; the second press activates
the Speed Limiter.
SPEED LIMIT
PROGRAMMING
The speed limit can be programmed
without necessarily activating the
device.
To store a speed value higher than
the displayed one, briefly press the
SET + button. Each time the button
is pressed, the speed increases by
about 1 km/h while keeping the button
pressed, the speed increases by
10 km/h.
To store a lower speed value than the
displayed one, press the SET – button.
Each time the button is pressed, the
speed decreases by about 1 km/h
while keeping the button pressed, the
speed decreases by 10 km/h.
DEVICE ACTIVATION/
DEACTIVATION
Device activation: press the SET + or
SET – buttons.
The activation of the device is indicated
by the green "LIM" symbol on the
display.
Device deactivation: press the CANC
button. The last set speed is crossed
out and displayed in grey.
Device reactivation: press the RES
button. The last set speed will be
restored.
EXCEEDING THE
PROGRAMMED SPEED
By fully depressing the accelerator
pedal, the programmed speed can be
exceeded even with the device active
(e.g. in the event of overtaking).
The device is disabled until the speed
drops below the set limit, after which it
reactivates automatically.
DEACTIVATING THE
DEVICE
To disengage the system press button
(A) fig. 131.
WARNING Activating the electronic
Cruise Control or Adaptive Cruise
Control function deactivates the device.
Automatic off of the device
The device switches off automatically
in the event of a system failure and
the grey "LIM" symbol appears on the