195
REPLACING A BULB
193) 194) 195)
73) 74)
GENERAL
INSTRUCTIONS
Before replacing a bulb check the
contacts for oxidation;
burnt bulbs must be replaced by
others of the same type and power;
always check the headlight beam
direction after changing a bulb for
safety reasons;
when a light is not working, check
that the corresponding fuse is intact
before replacing a bulb. For the
location of fuses, refer to the "Fuses
replacement" chapter in this section.
WARNING When the weather is cold or
damp or after heavy rain or washing,
the surface of headlights or rear lights
may steam up and/or form drops of
condensation on the inside. This
is a natural phenomenon due to the
difference in temperature and humidity
between the inside and the outside
of the glass which does not indicate
a fault and does not compromise the
normal operation of lighting devices.
The mist disappears quickly when
the lights are turned on, starting from
the centre of the air vent, extending
progressively towards the edges.
To Next Page
Loading...
