STARTING AND DRIVING
184
"Vehicle" page (fig. 178) you can set
the start and end time at which the
high-voltage battery is to be charged.
The end time of each charging interval
can be set as "charge to completion",
in which case the end time will be
deselected. For more information,
see "Settings" in the "Vehicle mode"
paragraph in the "Multimedia" section).
NOTE DC recharging (Mode 4) does
not include hourly programming.
178 AB0A0510
USING SCHEDULED
CHARGING
After programming and selecting the
desired charging intervals (up to a
maximum of three), plug in the charging
cable, following the charging procedure
indicated in the "Alternating current
(AC) charging at home", "Fast home
charging procedure from wallbox
charging station", "Charging procedure
from public charging station (AC)"
sections. Charging will start at the
selected time.
While the system is waiting for the
charging interval, the LED lights up (A)
fig. 179 (located next to the charging
port) and the LEDs (B) will illuminate in
a blue light sequence.
When charging is in progress
according to a programmed time, LED
(A) fig. 179 and LEDs (B) will light up
green flashing/fixed depending on the
state of charge of the battery portion
indicated by the LED. The fixed green
light indicates that the battery portion is
fully charged.
If the charging cable is inserted and
there are no selected charging times on
the Uconnect™ system, charging will
start immediately (see chapter "Using
immediate charging").
To perform scheduled charging with
"charge to completion" option, the
plug must be inserted within 5 minutes
before the scheduled start.
You can move on to the next
scheduled charging interval while an
immediate charging operation is in
progress by unlocking the ports and
pressing button (A) fig. 180 on the port.
WARNING the button (A) fig. 180 on
the port remains active for 1 minute
after the doors are locked.
179 F0S1065
180 F0S1067
USING IMMEDIATE
CHARGING
When the charging cable is inserted
and there are no charging schedules
selected, the cable will be locked and
the immediate charging procedure will
begin. LED (B) fig. 180 and LEDs (B)
fig. 179 will light up green flashing/fixed
depending on the state of charge of the
battery portion indicated by the LED.
The fixed green light indicates that the
battery portion is fully charged.
To Next Page
Loading...
