109
Under special conditions (e.g. car
loaded asymmetrically on one side,
towing a trailer, damaged or worn tyre,
fitting the space-saver wheel, use
of the "Fix&Go" tyre repair kit, fitting
snow chains, fitting different tyres on
the axles) the system may provide
false indications or be temporarily
deactivated.
If the system is temporarily deactivated
the warning light flashes for about
75 seconds and then is continuously
on; at the same time, the display
shows the shape of the car and the
symbols "– –" will appear next to each
tyre.
This warning is displayed also after
the engine has been switched off and
then on again if the correct operating
conditions are not restored.
In the case of abnormal signals, it is
recommended to perform the RESET
procedure. If the indications appear
again after a successful RESET, check
that the tyres used on all four wheels
are the same and that the tyres are
not damaged. As soon as possible,
refit the standard tyre instead of the
space-saver wheel, remove the snow
chains, if possible, check correct load
distribution and repeat the RESET
procedure by driving on a clean,
tarmacked road. If the indications
persist, contact a Dealership.
ATTENTION ASSIST
SYSTEM
(where provided)
This is an auxiliary driving assistance
system that detects when the driver is
tired.
ACTIVATION / DEACTIVATION
The system can be
activated/deactivated via the "Settings"
menu of the Uconnect™ system
(see "Settings" in the"Vehicle mode"
paragraph in the "Multimedia" section)
or via the instrument panel (see
"Settings" in the "Display" paragraph
in the "Knowing the instrument panel"
section).
SYSTEM INTERVENTION
The system intervenes if the camera in
the middle of the windscreen fig. 104
detects that the driver is tired, based
on variations in car trajectory and
getting too close to the side of the
road.
104 AB0A0538
The (red) symbol appears on
the instrument panel screen with a
dedicated message suggesting the
driver to stop and take a break. An
acoustic warning is also emitted.
If the driver accepts the suggestion
provided by the system and stops for
a pause, by pressing the OK button
on the left side of the steering wheel,
the message will disappear from the
display and the symbol will be
displayed in the dedicated area of the
instrument panel display up to the next
time the engine is started/stopped.
If the driver ignores the warning
provided by the system and does
not stop, the message will remain on
the instrument panel display until the
OK button located on the left hand
side controls of the steering wheel is
pressed. The symbol , will remain
displayed in the dedicated area of the
instrument panel display.
IMPORTANT In the event of a system
fault, the amber symbol appears on
the instrument panel display.
LANE CONTROL SYSTEM
DESCRIPTION
The Lane Control makes use of a
camera located on the windscreen to
detect the lane limits and calculate the
position of the car within such limits,
To Next Page
Loading...
