175
CHARGING SYSTEM/
MAINTENANCE/CLEANING
The device is maintenance-free.
If you need to clean the device, use a
soft cloth slightly dampened with a mild
detergent solution, then wipe dry with a
dry cloth. Do not use abrasive products
or flammable substances (e.g. alcohol,
petrol or their derivatives). Do not wash
the device with water, hazard of fire or
electric shock with the risk of serious
injury or death.
WARNING Only clean the device
when it is DISCONNECTED from both
the domestic charging port and the
charging port located on the car.
FCC (Federal
Communications
Commission)
SPECIFICATIONS
The state of charge Control Unit
complies with Section 15 of the FCC
Regulation.
The use of the device meets the
following two requirements:
1. This device does not cause harmful
interference.
2. Correct operation of the device may
be affected by interference from nearby
electrical/electronic devices.
This device is designed to withstand
radio frequency interference (RFI),
however, some factors (e.g., high
intensity radio signals or radio
transmitters in the vicinity of the device)
may cause it to malfunction. If you find
an anomaly in the operation of the
device, contact a Dealership.
WARNING Modifications and/or repairs
made incorrectly and NOT carried
out by a Dealership will invalidate the
warranty and the above requirements.
"MODE 3" CHARGE
CABLE
(for versions/markets where provided)
The car can be equipped with a "
Mode 3" charging cable fig. 163,
located inside a special bag in the
luggage compartment or inside the
special container below the luggage
compartment floor.
The "Mode 3" charging cable:
complies with EN 61851- 1, EN
62196- 1 and EN 62196- 2 standards;
can be used for a minimum
temperature of -40°C up to a maximum
temperature of +50°C.
This type of cable allows you to
connect to public alternating current
(AC) charging stations. The charging
speed may be faster than charging
through a domestic power socket.
Using this type of cable it is possible to
charge the car with a current of up to
16A.
NOTE After use, remember to replace
the protective covers on both sides of
the charging cable correctly to prevent
moisture and/or dust from entering the
cable charging port connections.
163 F0S1064
"MODE 4" CHARGING
CABLE - FAST CHARGE
This can be used to charge from DC
(direct current) public charging sockets.
The charging cable is connected to the
charging station.
The charging procedure can be faster
than with AC charging stations.
To Next Page
Loading...
