269
Select this button to choose
between audio instructions,
warning only or no sound.
Map update
To ensure optimal performance, the
navigation system must be updated
periodically. For this, the Mopar Map
Care service offers a new map update
every three months.
The updates can be downloaded from
the maps.mopar.eu website and
installed directly on the Uconnect™
system. All updates are free of charge
for 3 years from the start of the
warranty on the car.
The navigation system can also be
updated at a Dealership.
NOTE The dealer may charge for
updating the navigation system.
Voice Commands
NOTE Voice entry of addresses is
only supported in the country in which
you are located and provided that
the system language matches the
local language. For example, if the car
is located in Italy, it will be possible
to enter Italian addresses only if the
system language is set to "Italian".
The following voice commands can be
given after pressing the button on the
steering wheel :
Find <
PDI
> (Point of Interest)
near/along the route
Let's go <
home
>/<
to work
>
Go to <
address
>
Go to <
city name
> centre
Drive to <
address
>/<
PDI
>/<
junction
>
Navigate home
Go via home
Clear route
Recent Destinations
Stop at a recent destination
2D view
3D view
Volume adjustment
The volume of the navigation system
can only be adjusted when the
navigation system provides voice
commands.
VEHICLE MODE
Pressing the "Vehicle" graphic button
to access the pages: "Electric
Vehicle", "Controls" and "System
Settings".
Electric vehicle
The following submenus are
available to the user on the "Electric
vehicle" page: Power flows, History,
Programming and Charge Status.
Power Flow shows in a chart the
power flow used by the battery, the
electric motor and the climate control
system.
History shows the power flows used
up to 15 minutes before or in the
previous 7 days.
Programming can be used to
program the charging of the high
voltage battery or climate control
system when the car is parked.
The page shows a summary of the
programmed charging and climate
control system operations with
respective times and days of activation.
Select "New programming" to define a
new programmed charging or climate
control system operation.
When programming a battery charging
operation, select "Operating frequency"
to set the day and time for the start and
end of charging.
When programming the climate control
system, a pop-up with the ignition
device in the OFF position will ask
the user whether to recharge the
high-voltage battery or not despite the
programmed function. Set the desired
day and time to start the climate
control system from this page.
The Charging status shows the
current battery level and gives an
estimate of the maximum and minimum
charging time (depending on the power
supplied by the charging station). For
home charging, you can also set five
To Next Page
Loading...
